Other my Maverick custom intake

[megadesertdiesel]

my Maverick custom intake, its complete 1/8/13

yeah yeah i just cant leave anything alone. So i had most of the parts in my garage, i just needed to pickup a 2.75" x 3" silicone adapter hose to connect from the throttle body to the 3" tube.

I had a new 4" AFE filter and outerware in the garage and it fit perfect under the hood so i made an adapter for it.

first i made a splash shield to keep water and mud off the filter.

three dzus tabs later its solid

4" AFE filter, 3" 90* elbow and a 3" x 4" reducer.

after a little welding today it looks like this

i still need to drill a hole in the tab and mount it.

 

[the stripping shop]

i hope you know of a good pipe welder lol looks good

 

[az_amsoil]

Nice work Mike!

 

[skunx]

that looks trick, hopefully i can get my maverick back quick so i can do something similar.. any pros or cons yet.?

 

[megadesertdiesel]

that looks trick, hopefully i can get my maverick back quick so i can do something similar.. any pros or cons yet.?

Test king tonight. I hear it might not have enough fuel at wot. I will find out.

 

[megadesertdiesel]

i completed it and buttoned up the fenders. Eff those clips i didnot put any back on. I will need to use one just in front of the tilt column though.

i did run it down the street a few times and at 65mph foot to the floor. I did not notice it running differently. Must be on the computer where you see the lean condition.

 

[dev's rzr]

Nice job

 

[megadesertdiesel]

i drove it to Weller Racing today and she runs good. 73mph down the road BRRRRRRRRRAAAAAAPPPPPPPPP

 

[sand shark]

Nice job.

 

[Ali Baba]

i drove it to Weller Racing today and she runs good. 73mph down the road BRRRRRRRRRAAAAAAPPPPPPPPP

Nice! Clean work btw!